Service Mode Operation - Sony DXC-D30WSP Service Manual

2-7. SERVICE MODE OPERATION

• SERVICE mode:
Commonly, user can operate the BASIC menu and ADVANCE menu. In addition to these menu, service engineer can
operate the SERVICE menu.
To enter the service mode by adjusting S105 (OPE⇔ADJ) on the SW-791 board.
• Menu screen:
When the S105 on the SW-791 board is set to ADJ, following menu select screen is appeared.
Menu select screen
OPEN MENU (YES
SERVICE
Move the cursor to menu item by STATUS / MENU switch, select the menu by UP 4 switch or DOWN $ switch.
(The menu is cyclically changed to SERVICE ↔ BASIC ↔ ADVANCE ↔ SERVICE.) To enter the "SERVICE"
menu, perform as follows.
1 Select the "SERVICE" by UP 4 switch or DOWN $ switch.
2 Move the cursor to "OPEN MENU (yes→4)" by STATUS / MENU switch.
3 Push the UP 4 switch. Then, the "Page" of menu is displayed.
After performing the page of each menu, normally, the operation is performed the menu. When quitting the each menu,
the screen is returned to the Menu Select Screen.
• Connection:
The menu screen is ensured by seen the viewfinder or MONITOR OUT of DXC-D30WS (for NTSC) or DXC-D30WSP
(for PAL).
2-10
)
DXC-D30WS/P(E)/V1