Table of Contents
Advertisement
Fitting the Lens
In the case of the DSR-300AK/300APK model, the
lens is already fitted. In other cases, use the following
procedure to fit the lens.
1
Remove the retaining rubber
which prevents the lens mount
from coming loose, then raise
the lens fixing lever, and
remove the lens mount cap.
2
With the lens fixing lever
turned fully counterclockwise,
push in the lens, aligning the
projection on the lens with the
cutout on the camcorder.
3
Supporting the lens, turn the
lens fixing lever fully
clockwise. Replace the
retaining rubber on the lens
mount.
Note
When removing the lens, rotate the lens fixing lever
with your finger on the curved part of the lever.
You could injure your finger if you rotate the fixing
lever with your finger on the tip of the lever.
Note
Be sure to turn off the power before fitting the lens.
Retaining rubber
Lens mount cap
Align and push in.
Chapter 2 Fitting and Connections
Lens fixing lever
33
Advertisement
Table of Contents
