Related Manuals for Havis DS-PAN-701
Summary of Contents for Havis DS-PAN-701
- Page 1 Owner’s Manual Havis Docking Station For Panasonic Toughpad FZ-G1 DS-PAN-700 Series DS-PAN-701 DS-PAN-702 DS-PAN-703 DS-PAN-701-2 DS-PAN-702-2 www.havis.com 1-800-524-9900...
- Page 2 Before Beginning (Original Instructions) Havis is pleased to provide this Owner’s Manual to aid in the proper installation and use of the DS-PAN-700 Series Docking Station for the Panasonic Toughpad FZ-G1. For questions regarding the set-up of your DS-PAN-700 Series Docking Station, please contact Havis at 1-800-524-9900 or visit www.havis.com for additional...
-
Page 3: Table Of Contents
Bruce Jonik, Director of Engineering , Havis, Inc. FCC 47CFR, Part 15 compliance: This is an FCC Class B device. Any changes or modifications to the model DS-PAN-70X not expressly approved by Havis, Inc. could void the user's authority to operate this equipment. -
Page 4: Port Replication Capability
(ANT. A / ANT. B) (D-Sub 15 pin) HDMI BOTTOM of Docking Station NOTE: Antennas only available on select Docking Station models (DS-PAN-701-2, DS-PAN-702-2) Antenna Identification (DS-PAN-701-2, DS-PAN-702-2) In reference to the Panasonic FZ-G1 Upper/Lower Antenna connections • HAVIS ANTENNA = PANASONIC LOWER •... - Page 5 Parts Included (continued) Docking Station (DS-PAN-701-2 shown) Barrel Lock Latch Handle Latch Hook Docking Connector Pass-Through RF Antenna Ground Pins Tablet Access Window Strain Relief Anchor Points Mounting Holes (x4) Ports (VESA 75mm Hole Pattern) Strain Relief Mount Points Pass-Through...
-
Page 6: Installation
(Hardware Kit Item 3), eight (8) Washers, M4 (Hardware Kit Item 4), and four (4) Lock Washers, M4 (Hardware Kit Item 5), secure the Docking Station to device. Torque screws to 20 in-lbs (2.3Nm) ± 10%. Havis Desktop Stand installation (sold seperately, Part # DS-DA-218). Washer, M4... -
Page 7: Cable Management
Tie off cables onto a stationary part of the mounting system. Collect cables and secure This loop must be large enough to the mounting system. to allow full range of expected rotation and extension without (Note: Mounting system not included) stressing connections. www.havis.com • 1-800-524-9900... -
Page 8: Operation - Docking
Operation - Docking TO ENSURE A PROPER CONNECTION, PLEASE READ THE FOLLOWING BEFORE DOCKING YOUR TABLET. Hold your Toughpad FZ-G1 in landscape orientation, ensuring the Docking Connector is on the bottom. (NOTE: Power button will be on the bottom right) DO NOT FORCE TABLET ONTO DOCKING STATION. - Page 9 While holding the Tablet firmly against the bumpers, pull forward and down on the Latch Handle to secure tablet in place. NOTE: The Latch Handle will drive the Latch Hook over the front of the tablet. Pull Latch Handle until it snaps into position. www.havis.com • 1-800-524-9900...
-
Page 10: Operation - Undocking
Operation - Docking (continued) For theft deterrence, secure tablet by locking Docking Station with supplied key (Hardware Kit Item 2). Operation - Undocking If previously locked, unlock Docking Station using supplied key. While holding tablet with one hand, lift only the Latch Handle up and rearward. -
Page 11: Installation Of Usb Map Light (Ds-Da-102 - Optional)
Installation of USB Map Lighting (DS-DA-102 - Optional) DS-DA-102 - Havis Night Eyes 2 (USB Powered LED Map Light) (For further Installation Instructions, refer to the Instructions included with DS-DA-102) Slide P-Clip over base of Map Light as shown, then line up the mounting hole on P-Clip with Mounting Hole on Docking Station. - Page 12 Related Products Havis offers a wide variety of accessory products specifically for use with the DS-PAN-700 Series Docking Station. For more information or to order, please visit www.havis.com. DS-DA-218 Desktop Stand for Tablet Docking Stations Durable stand for mounting tablet Docking Stations for use in the home or office.