Aztech Cable/DSL Wireless Broadband4-Port Router Easy Start page 9

C. Connect to an Existing Network (DHCP Client)
With the Auto MDI/MDIX feature, both cross and straight UTP cable can be utilized.
Step 1:Connect Existing Network via an Ethernet Cable to the Modem port of the Cable/DSL
Wireless Router.
Step 2:Connect the computer to the LAN port of the Cable/DSL Wireless Router. Refer to
the section on
notebook" follow by
Browser".
Step 3:Access the Router. Refer to the section on
Step 4:Under Quick Configuration, select
Click Apply
Step 5:Check if connection type is
Local IP address will display under IP Address once Local connection is establised.
Step 6:You are now connected to your Existing Network.
This type of connection is for those who wish to extent their Existing Network. You
may need to configure other setting on the Cable/DSL Wireless Router to match your
Existing Network.
To Modem Port
Cable/DSL
Wireless
Router
"Connecting the Cable/DSL Wireless Router to your Computer/
"Configuring Your Ethernet Card"
and Reboot the Router for the setting to take effect.
DHCP Client
To LAN Port
and
"Accessing To The
DHCP Client configuration.
in Overall status
Easy Start Easy Start Easy Start Easy Start Easy Start
Computers or
Notebooks with
Ethernet Network
Cards
Computers or
Notebooks with
Wireless PC Cards
or USB Client
"Configuring Your Internet
Router".
under the WAN section.
9