Aztech Cable/DSL Wireless Broadband4-Port Router Easy Start page 6

Easy Start Easy Start Easy Start Easy Start Easy Start
Back Indicators
POWER SWITCH
To power on or off the modem.
DC IN
To connect to the Power Adapter that comes with your package.
RESET
To reset your CABLE/DSL Wireless Router to factory default settings.
Please refer to the below footer
ETHERNET
10/100 Base-T Ethernet jack (RJ-45) to connect to your Ethernet Network card or
Ethernet Hub / Switch
Modem
To connect to the CABLE/DSL modem.
RF Antenna
0
180 2.4Ghz Wireless Antenna.
2 To activate the reset function:
- Ensure that your CABLE/DSL Router is powered on.
-There are two ways to reset.
1) Use a paper clip or a pencil tip to depress the reset button and release. This will do a
normal reboot with the last saved setting. At this point, the WAN (if connected) and the ETHERNET
indicators will light up. The reset is in progress.- When the indicator light up or blinking, it means
that the reset process is completed.
2) Use a paper clip or a pencil tip to depress and hold the reset button for 10 seconds. This
will reset the router to factory default. At this point, the WAN (if connected) and the ETHERNET
indicators will light up. The reset is in progress.- When the indicator light up or blinking, it means
that the reset process is completed. The factory default settings are now restored.
6
2 on how to activate the reset function.