Table of Contents
Advertisement
Matrix Switchers Control Program
Starting the program
Many items found in the Matrix Switchers Control Program (the WCP) are also
accessible via optional front panel controls (see chapter 3, "Operation") and under
SIS control (see chapter 4, "SIS Programming and Control"). The Matrix Switcher
Help Program provides information on settings and on how to use the control
program itself.
1.
To run the Matrix Switchers Control Program, click Start >
Programs > Extron Electronics > Matrix Switchers >
MATRIX Switcher + Control Pgm.
The Comm Port Selection window (figure 5-22) appears.
Figure 5-22 — Comm port selection window
2.
Choose the comm port that is connected to the matrix switcher's RS-232 port,
IP [LAN], or Emulate.
3.
If you selected IP [LAN] in step 2, the IP Connection window appears
(figure 5-23).
Figure 5-23 — Address and password entry
MPX Plus 866 A Media Presentation Matrix Switcher • Switcher Software
If you selected a comm port, check the baud rate
displayed in the comm port selection window. If you
need to change the baud rate, click on the Baud button
and double-click on the desired baud rate.
Click Ok and proceed to step 4.
If you selected IP [LAN], click Ok and proceed to step 3.
If you selected Emulate, click Ok and see "Using Emulate mode" on
page 5-57.
5-41
Advertisement
Table of Contents
