Table of Contents
Advertisement
Matrix Software
Matrix Software, cont'd
Two software programs accompany the CrossPoint Plus Series switchers:
•
•
Both programs are compatible with Windows 95/98, Windows NT, Windows M.E.,
and Windows 2000. Updates to these programs can be downloaded from the
Extron Web site (http://www.extron.com).
Matrix Switchers Control Program
Installing the software
The program is contained on a set of single 3.5-inch diskettes, and you should load
and run the program from the hard drive.
To install the program from the floppy disk to the hard drive, run Setup.exe from
the floppy disk and follow the instructions that appear on the screen. The program
occupies approximately 1 MB (megabyte) of hard-drive space.
By default, the Windows installation creates a C:\MTRX directory, and it places
two icons (Matrix Switcher+ Control Program and Matrix Switcher+ Help) into a
group or folder named "Extron Electronics".
Using the software
Overview
This section is an overview of the Extron Matrix Switcher+ Control Program. The
help function contains additional information. See "Using the help system" on
page 5-5 for details.
1.
2.
3.
5-2
CrossPoint Plus Matrix Switchers • Matrix Software
The Extron Matrix Switchers Control Program (Extron part number
29-015-01), which communicates with the switcher via the RS-232/RS-422
port, provides an easy way for you to set up ties and sets of ties.
If your CrossPoint Plus Series switcher was previously set up for RS-232, and
your computer comm port uses RS-422, you must change the switcher cabling
to match the computer interface. See Appendix B, Reference Information, for
details.
The Extron Button-Label Generator, which allows you to design and print
labels for the CrossPoint Plus front panel buttons.
The program was designed to control most Extron matrix switchers, but its
operation is limited to the features and configuration of your
CrossPoint Plus Series switcher.
To run the Matrix Switcher+ Control Program, double-click on the Matrix
Switcher+ Control Program icon (shown at left) in the
Extron Electronics group or folder.
Click on the comm port that is connected to the RS-232/RS-422 port of the
switcher. To set up the software without attaching the switcher to the
computer, see "Using emulation mode" on page 5-5.
The Extron Matrix Switcher+ Control Program window (figure 42 and
figure 43) displays the current configuration of the attached matrix.
To set up audio in follow mode (audio and video have the same tie
configuration), select the Group box at the bottom of the window. To set up
audio in breakaway mode (audio and video have different tie configurations),
deselect the Group box.
Advertisement
Table of Contents
