Table of Contents
Advertisement
Operation, cont'd
Example 6: Setting the RGB delay for an output
In the following example, the RGB delay is increased for ties to output 1. The steps
show the front panel indications that result from your action.
1.
2.
3.
N An output from the low resolution video group cannot be selected.
Press and release the
Output 1 button.
The button lights green.
1 2 3 4
COMPUTER/AUDIO O
N The RGB delay is protected when front panel lock mode 2 is selected. You
3-24
MPX Plus 866 A Media Presentation Matrix Switcher • Operation
Clear all selections: Press and release the Esc button.
Press and release the Esc button.
C O N T R O L
VIEW
ESC
ENTER
PRESET
The button flashes once.
Select Video mode: Press and hold the Video button for approximately 2
seconds.
Press and hold the Video
button until it blinks.
VIDEO
2 seconds
Release the button.
Select an input: Press and release the output 1 button.
The input buttons 1 through 10 display the selected output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the green input buttons display 3.5 seconds of RGB delay.
0.5
1.0
1.5
2.0
2.5
COMPUTER INPUTS
1 2 3 4 5 6 7 8
can view the delay in lock mode 2, but not change it from the front panel. See
"Setting the front panel Locks (Executive modes)" on page 3-44.
If front panel lock mode 2 is selected and you try to perform steps 4, the actions
are ignored and the Enter, Video, and Audio buttons flash.
VIDEO
3.0
3.5
9 10 11 12 13 14
VIDEO INPUTS
Advertisement
Table of Contents
