Table of Contents
Advertisement
Operation, cont'd
Selecting S-video or composite video
Low resolution video inputs 11 through 14 are individually configurable as either
composite video or S-video. View and change this variable from the front panel as
follows:
N The input video format is protected when front panel Lock mode 2 is selected.
1.
2.
3.
4.
5.
N •
Example 7: Selecting the video format for a configurable output
In the following example, the S-video format is selected for video input 13.
The steps show the front panel indications that result from your action.
1.
2.
3-26
MPX Plus 866 A Media Presentation Matrix Switcher • Operation
You can view the selected form of the input in Lock mode 2 but you cannot
change it from the front panel. See "Setting the front panel Locks (Executive
modes)" on page 3-44.
Press the Esc button to clear any input buttons, output buttons, or control
buttons that may be lit.
To enter Video mode, press and hold the Video button until the button begins
to blink green, then release the button.
Press and release one of Video Input buttons 11 through 14 to select that input.
Either Video Output button 7 or 8 lights to indicate the video format. Video
Output 7 indicates composite video and Video Output 8 indicates S-video.
Press and release the Video Output 7 or 8 button to select the associated video
format.
Press and release the Video button to exit the Video mode. The Video button
stops blinking.
Pressing the Enter or Preset button also exits Video mode. Pressing the
Preset button changes to Recall Preset mode.
•
For the switcher to recognize the change and create a new configuration map,
you must create a new tie for the input whose format was changed.
•
Exiting Video mode by pressing the Video button always returns the I/O
configuration to video and audio selected for configuration.
Clear all selections: Press and release the Esc button.
Press and release the Esc button.
C O N T R O L
VIEW
ESC
ENTER
PRESET
The button flashes once.
Select Video mode: Press and hold the Video button.
Press and hold the Video
button until it blinks.
VIDEO
2 seconds
Release the button.
VIDEO
Advertisement
Table of Contents
