Table of Contents
Advertisement
SIS
Programming and Control, cont'd
™
Host-to-Switcher Instructions
The switcher accepts SIS commands through the RS-232 ports and Ethernet port.
SIS commands consist of one or more characters per command field. They do not
require any special characters to begin or end the command character sequence.
Each switcher response to an SIS command ends with a carriage return and a line
feed (CR/LF =
is one or more characters.
Switcher-Initiated Messages
When a local event such as a front panel operation occurs, the switcher responds
by sending a message to the host. The switcher-initiated messages are listed below
(underlined).
(C) Copyright 2008, Extron Electronics, MPX Plus 866 A, Vx.xx, 60-796-01,
date, time]
The switcher initiates the copyright message when it is first powered on or when
connection via Internet protocol (IP) is established. "Vx.xx" is the firmware version
number. "68-796-01" is the switcher's part number. "date/time" is the date and time
of the connection and is only reported when the connection is made via the LAN
port.
]
The switcher initiates the password message immediately after the copyright
message when the controlling system is connected using TCP/IP or Telnet and the
switcher is password protected. This message means that the switcher requires an
administrator or user level password before it will perform the commands entered
via this link. The switcher repeats the password message response for every entry
other than a valid password until a valid password is entered.
]
— or —
]
The switcher initiates the login message when a correct administrator or user
password has been entered. If the user and administrator passwords are the same,
the switcher defaults to administrator privileges.
Qik
The switcher initiates the Qik message when a front panel switching operation has
occurred.
Sprnn
The switcher initiates the Spr message when a memory preset has been saved from
the front panel. "nn" is the preset number.
Rprnn
The switcher initiates the Rpr message when a memory preset has been recalled
from the front panel. "nn" is the preset number.
Innn•Audxx
The switcher initiates the Aud message when a front panel input audio level change
has occurred. "nn" is the input number, • is a space, and "xx" is the dB level.
Outnn•Volxx
The switcher initiates the Vol message when a front panel output audio volume
change has occurred. "nn" is the output number, • is a space, and "xx" is the
volume level.
4-6
MPX Plus 866 A Media Presentation Matrix Switcher • SIS Programming and Control
]
), which signals the end of the response character string. A string
Password:
Login Administrator
]
]
Login User
]
]
]
]
]
Advertisement
Table of Contents
