Section.3.-.Wing.and.tail.installation - Hangar 9 CAP 232G ARF Assembly Manual

Section 3 – Wing and Tail Installation
Required Parts
•.Wing.panels.
•.Wing.tube.
•.1/4-20.x.2".nylon.bolt.(2). •.3mm.washer.(4)
•.3mm.x.15mm.machine.screw.(4)
Required Tools and Adhesives
•.30-minute.epoxy.
•.Hobby.knife.

.Step 1
Remove.the.two.4-40.x1/2".screws.securing.the.hatch..
to.the.fuselage..Remove.the.hatch.and.store.it.in.a.safe.
place.until.later.

.Step 2
Locate.the.wing.tube.and.carefully.slide.it.into.one.
wing.panel..Slide.the.wing.(with.tube).into.the.wing.
tube.opening.in.the.fuselage..Make.sure.the.wing.panel.
alignment.pins.slide.into.the.holes.provided.in.the.
fuselage..Be.sure.the.alignment.pins.are.secure.in.the.
wing.halves.before.installing.the.wings..If.they.are.not,.
remove.the.pin.and.apply.a.small.amount.of.thin.CA.into.
the.tube.socket.and.reinstall.the.alignment.pin.
14
•.Fuselage
•.Stabilizer.tube
•.Phillips.screwdriver
•.Threadlock

.Step 3
Carefully.slide.the.remaining.wing.panel.onto.the.wing.
tube.that.projects.from.the.fuselage..The.fit.may.be.tight;.
use.caution.when.inserting.the.wing.panels.onto.the.wing.
tube.and.fuselage.

.Step 4
Secure.the.wing.panels.using.the.1/4-20.x.2".wing.bolts.