Table of Contents
Advertisement
12 - 8 IGN 1 ON waiting time
You can configure IGN 1 ON waiting time that determines the time between turning IGN ON
and operating the starter motor when the brain attempts engine start.
● Note - If the vehicle is diesel and the warm-up sense wire is connected, the
starter motor is operated when the warm-up sensor detects the glow plugs
- regardless of this setting. Otherwise, the vehicle will crank when the
programmed time has expired.
12 - 9 Starter motor operation time
●
when connected in alternator/voltage sense mode there is no need to change
this time if the vehicle starts consistently. If the start overcranks, reduce the time.
If the start does not crank long enough increase the time. Adjustable from 0.1
to 1 second.
●
when it connected in TACH mode this setting controls the number of tach pulses
the unit must see before releasing the starter. A lower setting will fine tune the unit
to disengage the start earlier, while a higher value will cause the unit to crank the
vehicle longer. Adjustable from 1 to 10 tach pulses.
12 - 10 Exit
This menu is used to finish the configuration without transmitting the changed configuration
to the brain. The changed values are saved in the permanent memory of the remote control,
and you can transmit the values later.
● Note - The values must be saved to the brain for them to be active. To save to the
brain press the "A" button.
v4.2
29
Advertisement
Table of Contents
