DesignTech AirWolf Installation Manual page 2

Before installing the system
Model #20096 basic model without Shock Sensor or Siren.
Model #20097 same as #20096 but with extra Valet (1-way) transmitter.
Model #20098 Complete with Shock Sensor and Siren.
Model #20099 same as #20098 but with extra Valet (1-way) transmitter.
Thank you for choosing DesignTech's AIRWOLF Two-Way Remote Car
Starter. The AIRWOLF units have been carefully designed and built with
customer convenience in mind. We encourage you to fully read this manual
before installing and using this system.
Caution
1. For installer and user safety, carefully read and understand this manual before
installation.
2. Have the system installed by an authorized dealer, or an experienced installer.
3. Several safety precautions for the installer/user:
- Do not attempt to remotely start the vehicle if it is in GEAR.
- Do not attempt to remotely start the vehicle if the ignition is on.
- Do not remotely start the vehicle if it is indoors or in a poorly ventilated area.
- Do not attempt to remotely start the vehicle if anyone is standing in front
or behind of the vehicle.
- Do not attempt remotely start the vehicle if anyone is inside of the vehicle.
- Always apply the parking brake and place the transmission in Park or Neutral.
4. If any problems occur, discontinue use and consult your dealer/installer for help.
On cars with airbags, you may notice bright yellow tubes or harnesses underneath the
steering column area. DO NOT tamper with these wires in any way, soas to prevent
personal injury and/or damage while working near the car's air bag system.
Battery gases are explosive. Do not smoke while working near the car's battery.
When working the wires through the car's firewall, be sure to protect them from sharp
metal edges and from hot surfaces on the engine.
2
v4.2