Table of Contents
Advertisement
10. Programming the remote control
Step 1
Door OPEN
●
Open the door and turn the ignition key to ON position.
Step 2
Step 3
The remote control will play a
melody when learned.
Adding Additional Handheld Remote Controls
Up to 4 two-way remote controls and 4 one-way remote controls can be used
with one vehicle. Anytime within 5 minutes - and before exiting the learning
mode - simply teach it another remote control. Once you have completed the
learning of all remote controls, simply turn off the ignition and close the door.
❃ Note Door pin wire (CON 7) must be connected and both IGN #1 and ACC
(CON 1) must see + 12 Volts.
v4.2
Ignition key ON
Press and hold the buttons A
●
and D at the same time for more
than 2 seconds.
●
If the remote control has been
programmed
the
remote
play a melody.
●
Teaching
a
control will erase previously
learned remotes.
successfully,
control
will
new
remote
23
Advertisement
Table of Contents
