Table of Contents
Advertisement
➅ Blue : Siren output wire (
wire
➆ White/Brown : Re-arm output.The 300mA transistor output to rearm the
factory alarm.
This output provides a negative (300mA max) signal when you lock the doors from
remote control. This output can be used to rearm the factory alarm. The output
will pulse once if the locks are in normal mode. If the locks are programmed for
double pulse, this output will pulse twice.
➇ Brown/White: Dis-arm output. The
factory alarm.
This output provides a negative (300mA max) signal when you unlock the doors from
remote control. This output can be used to disarm the factory alarm. The output will
pulse once if the locks are in normal mode. If the locks are programmed for double
pulse, this output will pulse twice. Note: If the vehicle contains a factory alarm you
MUST unlock the doors by remote (to disarm the factory alarm) prior to remote starting
the vehicle.
➈ Red/ Yellow : Auxiliary 1 output
momentary or latching see page 26 (Timing Configuration).
➉ Red / Blue : Auxiliary 2 output
momentary or latching See page 26 (Timing Configuration).
Note
The Auxiliary outputs can be programmed to
12
3A power transistor)
R ed wire
300mA output used to disarm the
300 mA output. This output can be either
300 mA output. This output can be either
have a pulse or latched signal. You can
change the programming via remote control. (page 26)
B lue
v4.2
Advertisement
Table of Contents
