Table of Contents
Advertisement
12. Timing Configuration
Timing configuration allows the time adjustments of various features such as the operation
time for door locks, crank time for the starter motor, etc. Initially, the unit operated with
the default values as shown in the chart below. The default values are adequate
for most vehicles. However, if it is not working properly, the timing may
need to be configured to appropriate values. The changed timing is saved
in the permanent memory of both the remote control and the unit - and is
stored until the values are changed again.
Button A: to transmit data after completing the configuration.
Button B and C: to move menu or change the timing.
Button D: to select menu or finish the timing configuration.
For data transmission after completing the configuration of the unit, the ignition key should
be in the on position, and the hood and door should be open.
Timing Configuration
With
Function
Stater
Door Lock
1
Door Unlock
2
Auxiliary Output 1
3
Auxiliary Output 2
4
Trunk
6
Precauti o n Mode Wai t i n g
7
Ti m e After Cl o si n g Door
8
IGN ON Waiting Time
9
Cranking Time
10
Exit
If the desired value is the same as the default, configuration is not required.
When the configuration is completed, press button A to transmit the changed data
to the unit and finish the configuration.
26
LCD Display
Exit without transmitting changed data
(data is saved in the remote control)
Configurable
Default Value
Range
0.8 Seconds
0.1~9.9
Once
Seconds
0.8 Seconds
0.1~9.9
Pulse
Seconds
0.8 Seconds
0.1~9.9
1~99 Seconds
10 Seconds
2 Seconds
1~10 Seconds
TACH:4 pulse
1~10 Seconds
Alter :0.4 sec
v4.2
Advertisement
Table of Contents
