Signal Output Connector (Con 2) - DesignTech AirWolf Installation Manual

4. Signal output connector (CON 2 )
➁ Yellow: Parking light output ( 10A relay)
Parking light output (max of 10A) Connect this wire to the
parking light wire in the vehicle. The correct wire in the vehicle will show 12
volts only when the parking lights are turned on. When the parking lights are
off the wire will show 0 volts. NOTE: In most cases connecting to one wire in
the vehicle will illuminate all parking lights. If not, there will be multiple wires
you need to power, isolating each wire with a relay. This is especially true in
European vehicles. Note: See the following diagram if your vehicle requires a
NEGATIVE trigger to illuminate the parking lights.
Yellow
10
➀
N/A
➁
Parking light output (
Yellow
➂
N/A
➃
Trunk Release output ( 10A relay)
Green/White
➄
Starter interrupt Signal output ( 300mA transistor)
White
➅
Siren output (
Blue
➆
Rearm output for factory Alarm (
White/Brown
➇
disarm output for factory Alarm (
Brown/White
➈
Red/Yellow Auxiliary 1 output (
➉
Red/Blue Auxiliary 2 output (
N/A
11
Brown
12 Dome light output (
type
Yellow
type
10A relay)
3A power transistor)
300mA transistor)
300mA transistor)
300mA transistor)
300mA transistor)
300mA transistor)
v4.2