Table of Contents
Advertisement
Programming if connected in Voltage Sense mode
If the Alternator/Tachometer wire *IS NOT* connected to the tach wire as
per PAGE 19, perform the steps below. Do NOT use the Green Tach wire.
Connect the WHITE Voltage Sense wire to a source of 12 volts constant
power. This 12 volt source will allow Air Wolf to measure the output of the
alternator.
Step 1
Step 2
Manual
/Automatic
Loop
Step 3
Valet mode button for
more than 4 seconds
Step 4
Manual
/Automatic
Loop
Because the measured value is saved in the permanent memory of the unit, the
tach setting is saved even if the power is removed.
Note: Return the DIP switch to OFF after the setting.
❃ Note Door pin switch (CON 7) must be connected.
v4.2
DIP
Switch
Simple tone sounds once
DIP
Switch
●
Open the door
●
Place the DIP switch at ON position.
Alternatively you may open the
hood if the hood pin switch is
properly installed.
●
If you press and hold the Valet
button for more than 4 seconds,
the car makes a tone and the
function ends.
●
Place
the
to
the
OFF
close the hood.
DIP
switch
position
OR
25
Advertisement
Table of Contents
