Trigger Input Connector (Con 7) - DesignTech AirWolf Installation Manual

9. Trigger input connector (CON 7)

9-1 . Green : Tachometer (AC) Input
This wire is used to sense when the engine has started and disengages the starter motor. It
can be set to sense the alternator or tachometer as per below. If a tach wire is unavailable,
you can use the voltage sensing approach of step 9-6.
◆ Connection for TACH :
9-2. Gray/Black : Door pin switch
One of the door input wires MUST be installed to allow the unit to properly function,
including the programming and alarm functions. If your vehicle uses a negative trigger door
pin switch, connect this wire to a wire in the vehicle which shows 0 V when any door is
Open, and 12V when all doors are closed. NOTE: If your vehicle uses a positive trigger door
pin switch see "#3 GRAY (+) door pin switch wire." The AirWolf system will not properly
function without one of these door pin wires connected.
B rown (CON2 #12) B rown (CON2 #12)
o utput o utput
dome light dome light
v4.2
➀
Green Tachometer(AC) Input
➁
Gray/Black Doorpin Switch
➂
Gray Doorpin Switch
➃
Purple Hoodpin Switch
➄
Orange foot Brake
➅
Voltage sense
White
➆
Gray/White Trunk
➇
Red Glow
➈
Red/Black Glow
➉
Yellow/White Parking light
Connect the Green TACH input wire to negative
side of the tachometer coil.
Input
ground ground
Input
Input
Input
Input
IGN #1 Input see page 26
Input
Input
Input
Input
G ray / B lack G ray / B lack
19