Axis PrintPoint 140 BJC User Manual page 76

Upgrading over the
Network using FTP
Caution
AXIS PrintPoint 140 BJC User's Manual
To upgrade over the network using FTP, you will need the following:
• The file with the new print server software. The name of this file
is in the form product.version, e.g.
release 5.24. You may use any of the aforementioned methods to
obtain the new file.
• The AXIS PrintPoint 140 BJC must also be installed on the net-
work with TCP/IP as described in Basic Set Up for TCP/IP, on
page 22.
Follow the procedures below to upgrade the AXIS PrintPoint 140
BJC:
1. Log in to the AXIS PrintPoint 140 BJC with the command
ftp <host name>
your system host table.
2. You will be prompted for user id and password. Use the user id
, which has the default password
root
with the highest priority).
3. Issue the command
4. Issue the command
<software name>
e.g. 140.524.
5. Wait for the Flash load to finish. This normally takes 1 to 4
minutes. The unit will then automatically restart with the new
print server software.
Be careful not to interrupt the file transfer. If the transfer is
interrupted the AXIS PrintPoint 140 BJC may have to be
re-initialized by your dealer.
6. Log out using the command
your FTP version.
Appendix C : Updating the Software
140_524.exe
where <
host name>
pass
to change to binary transfer mode.
binary
put <software name> flash
is the name of the new print server software,
quit, bye
for software
is the name assigned in
( the user id
root
where
or depending on
exit
75