Axis PrintPoint 140 BJC User Manual page 28

Using RARP in UNIX
Using BOOTP in UNIX
AXIS PrintPoint 140 BJC User's Manual
Follow the step-by-step procedure below to use the RARP method:
1. Append the following line to your Ethernet Address table. This is
typically performed using the command
<Ethernet address> <host name>
Example
00:40:8c:10:00:86 npsname
2. Update your host table and alias name databases, as described
previously.
3. If it is not already running, start the RARP daemon. This is
typically performed using the command
4. Restart the AXIS PrintPoint 140 BJC to download the Internet
address.
Follow the step-by-step procedure below to use the BOOTP method:
1. Append the following entry to your boot table. This is typically
performed by editing the file:
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<Internet address>:\
:sm=<subnet mask>:gw=<gateway field>
Example:
npsname:ht=ether:vm=rfc1048:\
:ha=00408c100086:ip=192.168.3.191:\
:sm=255.255.255.0:gw=192.168.1.1
2. Update your host table and alias name databases as described
previously.
3. If it is not already running, start the BOOTP daemon. This is
typically performed using the command
Section 2: Basic Installation
/etc/ethers:
rarpd -a
/etc/bootptab
bootpd
27