Husqvarna Rider 13 Workshop Manual page 45

6
Draw the transmission wire along with the other
cabling. Place the wire at the bottom in the clamp,
under the articulated steering's bearing.
7
Put the wire in position and screw tight the casing
with the rear clamp.
8. Adjust the wire as directed in "Inspection and
adjustment of speed regulator". Connect the
rear linkage and fit the lock spring. Tighten the
rear lock nut for the linkage.
9. Check the setting of the neutral position contact.
See "Electrical system\Microswitch neutral
position".
10
Fix the hydrostatic transmission wire with a cable
ties.
11
Refit the frame plate using the four screws.
Reparation instructions
~80
43
English –