Checking And Adjusting Throttle Control; Replacing Articulated Steering Bearing - Husqvarna Rider 13 Workshop Manual

Checking and adjusting throttle control

Rider 13 and Rider 16
1. Detach the locking nut (1) on the ball joint.
2. Push the lock spring (2) forwards far enough
for the spherical socket (3) to be lifted off from
the pivot on the lever (4).
3. Press the throttle pedal to the bottom and
move the lever (4) forwards as far as it goes
using a screwdriver.
4. Adjust the position of the spherical socket (3)
on the connecting rod (5) so that it just fits over
the pivot on the lever. Fit the spherical socket
on the pivot.
5. Lock the setting with the lock nut (1) and press
the locking spring (2) into position.
IMPORTANT INFORMATION
Check that the locking spring goes
through the hole in the spherical socket.
5
1

Replacing articulated steering bearing

1
• Remove the engine according to the earlier
description (see "Removing engine").
• Block up the ride-on mower in front of the
articulated steering.
2 Rider 11
• Release the tensioning wheel spring (1).
• Release the clutch, gear and brake wire (2, 3
and 4) and remove the wires' holder plates (5
and 6).
2 Rider 13 and Rider 16
2
3
4
• Release the tensioning wheel spring (1).
• Release the hydrostatic transmission wire (2)
from the arm (3) and the casing from the holder
(4).
• Release the cable from the neutral position
contact (5).
• Release the brake wire from the arm under the
tank and the casing's holder from the rear frame
(6).
Reparation instructions
33
English –