Table of Contents
Advertisement
Reconnect the temperature sensor cable to the heat exchanger unit.
6.
Slide the insulation back in place on the In or Out water hose up against the coupling.
7.
Replace the air deflector plate
8.
Replace the fan unit
9.
Restore water flow to the MCS unit
10.
Complete the operation checklist (on page 111).
11.
Magnetic solenoid valve
The magnetic solenoid valve is a component of the water group located at the bottom interior of the MCS
unit.
The following tools are required for installation:
•
T-25 Torx driver
•
Phillips screwdriver
Removing the magnetic solenoid valve
Power down the MCS unit
1.
("Replacing the air deflector
("Replacing the fan
unit" on page 52).
("Restoring water
("Powering down the MCS
plate" on page 34).
flow" on page 112).
unit" on page 24).
Removal and replacement procedures 82
Advertisement
Table of Contents
