Replace the plastic lock washer above the paddle-wheel sensor.
3.
Route the paddle-wheel sensor cable through to the front of the MCS unit.
4.
Connect the paddle-wheel sensor cable connector to the X14 connector on the water group
5.
controller.
Replace the AC transfer switch
6.
Replace the condensation pump and sensors
7.
page 49).
Replace the air deflector plate
8.
Replace the bottom fan unit
9.
Restore water flow to the MCS unit
10.
Complete the operation checklist (on page 111).
11.
("Replacing the AC transfer
("Replacing the condensation pump and
("Replacing the air deflector
("Replacing the bottom fan
("Restoring water
switch" on page 28).
plate" on page 34).
unit" on page 45).
flow" on page 112).
Removal and replacement procedures 58
sensors" on