Table of Contents
Advertisement
Connect the two sensor connectors to the condensation pump.
2.
Connect the AC power cable to the condensation pump.
3.
Replace the air sealing plate
4.
Relocate the power inlet box back into position
5.
on page 95).
Replace the bottom fan unit
6.
Complete the operation checklist (on page 111).
7.
Fan unit
The three fan units are located at the rear of the MCS unit.
("Replacing the air sealing
("Relocating the power inlet box back into
("Replacing the bottom fan
plate" on page 36).
unit" on page 45).
Removal and replacement procedures 50
position"
Advertisement
Table of Contents
