Connect the seven electrical cables to the front of the water group controller.
6.
Replace the AC transfer switch
7.
Complete the operation checklist (on page 111).
8.
Water inlet coupling
The water inlet coupling is located on the inlet water hose connected to the MCS unit.
The following tools are required for installation:
•
5-mm Allen wrench
Removing the water inlet coupling
Power down the MCS unit.
1.
Shut off the water flowing into the MCS unit.
2.
("Replacing the AC transfer
("Powering down the MCS
("Shutting off the
switch" on page 28).
unit" on page 24)
water" on page 25)
Removal and replacement procedures 102