Table of Contents
Advertisement
Using two 18-mm wrenches, tighten the cap nut over the water temperature sensor.
3.
Route the water temperature sensor cable through to the front of the MCS unit.
4.
Connect the water temperature sensor cable connector to the water group controller connector
5.
labeled either X12 or X13.
Replace the AC transfer switch
6.
Replace the condensation pump and sensors
7.
page 49).
Replace the air deflector plate
8.
Replace the air sealing plate
9.
Relocate the power inlet box back into position
10.
on page 95).
Replace the bottom fan unit
11.
Restore water flow to the MCS unit
12.
Complete the operation checklist (on page 111).
13.
("Replacing the AC transfer
("Replacing the condensation pump and
("Replacing the air deflector
("Replacing the air sealing
("Relocating the power inlet box back into
("Replacing the bottom fan
("Restoring water
switch" on page 28).
plate" on page 34).
plate" on page 36).
unit" on page 45).
flow" on page 112).
Removal and replacement procedures 110
sensors" on
position"
Advertisement
Table of Contents
