Replace the condensation pump and sensors
9.
page 49).
Relocate the power inlet box back into position
10.
on page 95).
Replace the bottom fan unit
11.
Restore water flow to the MCS unit
12.
Complete the operation checklist (on page 111).
13.
Magnetic valve
The magnetic valve is a component of the water group located at the bottom interior of the MCS unit.
The following tools are required for installation:
•
T-25 Torx driver
•
Phillips screwdriver
•
8-mm Allen wrench
Removing the magnetic valve diaphragm and spring
Power down the MCS unit
1.
Disconnect the main water lines at the quick disconnect couplings.
2.
Remove the bottom fan unit
3.
Relocate the power inlet box
4.
Remove the air deflector plate
5.
("Replacing the condensation pump and
("Relocating the power inlet box back into
("Replacing the bottom fan
("Restoring water
("Powering down the MCS
("Removing the bottom fan
("Relocating the power inlet
("Removing the air deflector
Technician repair removal and replacement procedures 118
unit" on page 45).
flow" on page 112).
unit" on page 24).
unit" on page 44).
box" on page 93).
plate" on page 33).
sensors" on
position"