Table of Contents
Advertisement
T-25 Torx driver
o
Wire cutters
o
•
Condensation pump and sensors
T-25 Torx driver
o
Phillips screwdriver
o
•
Fan unit
T-25 Torx driver
o
•
Flow meter paddle-wheel sensor
T-25 Torx driver
o
Wire cutters
o
Water hose fitting wrench (included with your original MCS unit)
o
Counter hold wrench (included with your original MCS unit)
o
•
Heat exchanger unit (HEX) with coupler
T-25 Torx driver
o
Water hose fitting wrench (included with your original MCS unit)
o
Counter hold wrench (included with your original MCS unit)
o
•
Heat exchanger unit (HEX) with ball valves
Adjustable wrench or pipe wrench
o
T-25 Torx driver
o
•
HEX coupling
T-25 Torx driver
o
Water hose fitting wrench (included with your original MCS unit)
o
Counter hold wrench (included with your original MCS unit)
o
Flathead screwdriver
o
Utility knife
o
•
Magnetic solenoid valve
T-25 Torx driver
o
Phillips screwdriver
o
•
Management module
No tools are required for this procedure.
•
Operator display
8-mm socket
o
Small Flathead screwdriver
o
•
Water group controller
T-25 Torx driver
o
Flathead screwdriver
o
8-mm socket
o
•
Water inlet coupling
Removal and replacement procedures 23
Advertisement
Table of Contents
