Mini-Sas Y-Cable Option - HP ProLiant DL360e Gen8 User Manual

Connect the rest of the drive cables required in this drive configuration. For more information, see
10.
"Storage cabling (on page 71)."
In the four-bay LFF drive cage configuration, HP recommends securing the excess length of the Mini-SAS
11.
cable by using the cable clip that came with the kit:
Use the two vertical dash marks in front of the fan cage to position the clip correctly, and then attach
a.
the cable clip.
Secure the excess length of the Mini-SAS cable in the cable clip.
b.
If you intend to use an FBWC module and capacitor pack, install these options now
12.
FBWC module and capacitor
Install the access panel (on page 20).
13.
Install the server into the rack
14.
Power up the server (on page 17).
15.
CAUTION:
all bays are populated with either a component or a blank.
Install the drives
16.

Mini-SAS Y-cable option

The Mini-SAS Y-cable in this option kit supports HP Smart Array controller board options in the eight-bay SFF
drive configuration.
To connect the cable option:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 18).
o
pack" on page 39).
("Installing the server into the
To prevent improper cooling and thermal damage, do not operate the server unless
("Installing a hot-plug drive" on page 32).
rack" on page 27).
Hardware options installation 36
("Installing the