Processor Option - HP ProLiant DL360e Gen8 User Manual

Power up the server (on page 17).
9.
After installing the DIMMs, use RBSU
protection mode.

Processor option

The server supports single-processor and dual-processor operations.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website (http://www.hp.com/go/productbulletin).
WARNING:
internal system components to cool before touching them.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
CAUTION:
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT:
installing the processor.
IMPORTANT:
In a multiprocessor configuration, to optimize system performance, HP recommends balancing the total
capacity of the DIMMs across the processors.
To install the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 17).
o
Remove the server from the rack (on page 18).
o
Remove the access panel (on page 19).
4.
("HP ROM-Based Setup
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
To prevent possible server overheating, always populate processor socket 2 with a
If installing a processor with a faster speed, update the system ROM before
Processor socket 1 must be populated at all times or the server does not function.
Utility" on page 83) to configure the memory
Hardware options installation 56