Figure 1-3 Connecting The Power Cable - Silicon Graphics Presenter Owner's Manual

2. Connect the power cable to the Presenter and then to an electrical
outlet, as shown in Figure 1-3. (Figure 1-3 shows the power cable for the
U.S.A. The power cable for your country may look different.)
Connect the socket end to the power connector on the base of the
Presenter.
Connect the other end to a three-pronged grounded electrical wall
outlet or power strip.
Note: The power supply for the Presenter is auto-ranging. With the
appropriate power cable or adapter for your country, you can plug the
Presenter into almost any power source (50-60 Hz, 110/220 VAC).
Figure 1-3 Connecting the Power Cable
You are now ready to use the Presenter monitor.
Setting Up the Presenter Monitor
To workstation
5