Figure 1-6 Placing The Presenter On The Overhead Projector - Silicon Graphics Presenter Owner's Manual

Chapter 1: Setting Up and Using the Presenter Monitor
12
11. Place the Presenter face down on the surface of the overhead projector so
that only the back of the Presenter is visible, and slide it under the two
clips on the projector to secure it. See Figure 1-6. Make sure the backlight
panel has been removed first.
Slide the Presenter under the two clips on the projector.
Rotate the base of the Presenter down so it is out of your way.
Figure 1-6 Placing the Presenter on the Overhead Projector
12. Open the file for the image on the Presenter that you wish to project.
If the image does not project properly, check that the Presenter is face
down on the projector's surface, and that the backlight panel has been
removed. For additional help, go to Chapter 2, "Troubleshooting."
If you think the problem might be with the Dukane overhead projector,
refer to its manual.
13. When you are finished with your presentation, turn off the overhead
projector, and replace the backlight panel, as shown in Figure 1-7.