Restarting The Presenter Monitor - Silicon Graphics Presenter Owner's Manual

• From a UNIX shell, enter:
monpanel
2. When the Monitor Control Panel appears, click Turn on Presenter or
Restart Presenter.
If you have a root password set, enter it when prompted, and click the
OK button.
If your CRT monitor is 1024 x 768 pixels, you see a message that turning
on the Presenter stops all running applications. Close any applications
for which you may lose data.
3. When you are ready for applications to be stopped, click Continue to
turn on Presenter.
For more information on using the Monitor Control Panel for the Presenter,
see the reference page (man page). From a shell window, type:
man monpanel

Restarting the Presenter Monitor

If the workstation is on and Presenter is disconnected, you can reconnect it
and restart it from the Monitor Control Panel on the CRT monitor. See the
steps below. Note that restarting the Presenter resets the backlight and bit
mode to their original settings, that is, nearly full backlight and 12-bit mode.
If you have no CRT monitor attached there are two ways you can restart
Presenter:
• Reconnect Presenter and restart the workstation.
• If you are on a network, use the Monitor Control Panel to restart the
Presenter. From another system on the network, log in to your system
remotely, and type
Follow these steps to restart Presenter:
1. Open the Monitor Panel in either of the following ways:
From the Find menu in the Toolchest, choose "Control Panels" and
double-click the monpanel icon.
at the shell prompt.
monpanel -restart
Turning on the Presenter
7