Turning Off The Presenter; Setting Up The Presenter On The Dukane Customized Projector - Silicon Graphics Presenter Owner's Manual

Chapter 1: Setting Up and Using the Presenter Monitor

Turning Off the Presenter

Setting Up the Presenter on the Dukane Customized Projector

8
From a UNIX shell, enter:
monpanel
2. When the Monitor Control Panel appears, click Restart Presenter.
The Presenter turns off automatically when you turn off the workstation.
If you have a CRT monitor connected to your workstation, you can
disconnect the Presenter's interface and power cables instead of powering
off the workstation. To restart the Presenter, connect the interface cable and
then the power cable. Then open the Monitor Control Panel on the CRT
monitor by choosing "Control Panels" from the Find menu in the Toolchest
and double-click the monpanel icon. Then click Restart Presenter.
Note: It's important when you reconnect the Presenter's cables that you
connect the interface cable first and then the power cable. Connecting them
in the reverse order results in a distorted image.
If no CRT monitor is connected to the workstation, you can disconnect the
Presenter's interface and power cables instead of powering off the
workstation. To restart the Presenter, reboot your workstation after
connecting the interface cable and the power cable.
If you are not planning to use the Presenter for a few hours, it's a good idea
to disconnect it. Leaving the display on for long periods of time shortens the
life of the display's backlight.
Caution: The Presenter is designed to function at maximum performance
and reliability with the Dukane Overhead Projector. If you use it with
another projector, cooling of the display, stable mounting, and brightness of
the projected image will all be compromised. A bright overhead projector
without proper cooling of the display may cause permanent damage to the Presenter.