Ricoh 2045 Operating Instructions Manual page 29

Messages/Second messages
Following output tray is full.
### Remove the paper. ###
HDD has a problem.
HDD has not been installed.
HDD is full.
IEEE 802.11b (Wireless LAN)
has a problem.
LCT has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
dLower Staple is almost
empty.
NV-RAM has a problem.
Output tray has been
changed.
Paper in duplex unit. Open
cover and remove paper.
Paper in staple tray. Open fin-
isher cover and remove pa-
per.
Description
The indicated output tray is
full.
Note
❒ "###" in the message rep-
resents a output tray.
An error has occurred in the
hard disk drive.
The Locked Print was per-
formed without the hard disk
installed, or the hard disk is
damaged.
The maximum hard disk area
size for form/font has been ex-
ceeded.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
IEEE 802.11b card was not in-
serted when the machine was
turned on, or it was pulled out
after the machine turned on.
An error occurred in the large
capacity tray.
There are a few staples re-
maining in the lower stapler.
An error has occurred in the
optional memory unit.
The output tray has been
changed automatically.
There is a misfeed in the du-
plex unit.
There is paper remaining in-
side the finisher.
Error & Status Messages on the Display Panel
Solution
Remove the paper.
Turn off the main power
switch, and on. If the message
appears again, contact your
sales or service representative.
Contact your sales or service
representative.
Delete unused form /font
types.
Delete stored files or reduce
the file to be downloaded.
Turn off the machine and
check the IEEE 802.11b card is
inserted correctly. Then, turn
on the machine again. If the
message appears again, call
your service center.
Turn off the main power
switch, wait five minutes, and
on again. If the message ap-
pears again, call your sales or
service representative.
Load in more staples.
Turn off the main power
switch, and on. If the message
appears again, call your sales
or service representative.
Select the proper output tray.
Open the cover of the duplex
unit, and remove the misfed
paper.
Open the cover of finisher, and
remove the paper.
4
23