The Machine Does Not Print - Ricoh 2045 Operating Instructions Manual

The Machine Does Not Print

Possible Cause
Is the power on?
Is the machine online?
Does the printer function
status indicator stay red?
Is there a warning status or
error message on the dis-
play panel?
Can you print a configura-
tion page?
Is the interface cable con-
nected securely to the ma-
chine and computer?
Are you using the correct
interface cable?
Was the interface cable
connected after the ma-
chine was turned on?
Is the signal status satisfac-
tory when using wireless
LAN in Infrastructure
mode ?
When using wireless LAN,
is the SSID correctly set?
Confirm the cable is securely plugged into the power outlet and
the machine.
Turn on the main power switch.
If not, press [Online] on the display panel.
If so, check the error message on the display panel and take re-
quired action.
If so, check the error message or warning status on the display
panel and take the required action.
If you cannot print a configuration page, there maybe a machine
malfunction. Contact your sales or service representative.
See p.36 "Printing the Configuration Page" for printing a configu-
ration page.
Connect the interface cable securely. If it has a fastener, fasten it
securely as well.
See "Connecting the Machine", Printer Reference 1.
The type of interface cable you should use depends on the com-
puter. Be sure to use the correct one. If the cable is damaged or
worn, replace it.
See "Connecting the Machine", Printer Reference 1.
Connect the interface cable before turning on the machine.
To check signal status, press { { { { User Tools/Counter} } } } on the display
panel, and then press [System Settings] on the display panel. On the
[Interface Settings] tab, select [IEEE 802.11b], and then press [Wireless
LAN Signal]. If signal quality is bad, move the machine to a location
where signals can pass or remove objects that might block signals.
Note
❒ You can check signal status only when using a wireless LAN
in Infrastructure mode.
Confirm on the machine's display panel that the SSID is correctly
set.
See "Interface Settings/IEEE 802.11b (Option)", General Settings
Guide.
The Machine Does Not Print
Solutions
4
25