Clamp Assembly - Chicago Electric 91995 Set Up And Operating Instructions Manual

To Assemble Additional Accessories:
1. A workpiece Clamp Assembly (3) can be installed by inserting the Assembly into
the hole located in the Guide Fence (3). Once inserted, lock the Assembly in
place with the Thumb Screw (35). To clamp the workpiece to the Base () of
the Miter Saw, turn the Adjusting Knob on the Clamp Assembly clockwise.
(See Figure K.)
2. A workpiece Holder (9) can be inserted into each side of the Base (), adjusted
for the desired length, and locked in place with the Thumb Screw (10). The
Holders should be used as supports when cutting longer length workpieces.
(See Figure K.)
THUMB SCREW (35)
gUIDE FENCE (37)
THUMB SCREW (10)
FIgURE K
The Safety Cover:
1. The transparent Safety Cover (53) automatically rotates to cover the Saw Blade
(5) when the Cover Case (9) is lifted. When the Cover Case is lowered, the
Safety Cover rotates back out of the way. (See Figure l, next page.)
2. Do not disconnect or remove the Safety Cover (53). Do not operate the
Miter Saw if the Safety Cover is damaged or missing. (See Figure l.)
3. If the transparent Safety Cover (53) becomes so dirty that the Saw Blade (5)
SKU 91995 For technical questions, please call 1-800-444-3353.

ClAMP ASSEMBlY

(36)
BASE
(8)
HOlDER
(9)
Page 15