Table of Contents
Advertisement
Hardware Options
Factory Option Sets
Factory Option Set #1
(Asynchronous Dial-up with V.42 bis Protocol)
(AT&F or AT&F1)
MODEM OPTIONS
DCE rate - 33600
Modulation automode
V.34 rate threshold high
V.34 asymmetric rate enabled
Normal originate
Fast train disabled
Auto retrain enabled
SQ auto rate disabled
Transmit clock internal
Dial line
Jack type RJ11
Line current disconnect long
Long space disconnect enabled
V.22 guard tone disabled
PROTOCOL OPTIONS
LAPM protocol enabled
MNP protocol enabled
Protocol fallback enabled
Data compression normal
Constant DTE speed
DTE flow control RTS
DCE flow control CTS
XON/XOFF pass through disabled DCD normal
Inactivity timer off
Break control 5
V.42 fast detect enabled
SPEAKER OPTIONS
Volume low
On until carrier detect
E-28
TEST OPTIONS
Bilateral digital loop disabled
DTE local test disabled
DTE remote test disabled
Remote commanded test enabled
Test timeout off
DIAL LINE OPTIONS
Tone dial
Auto dial #1
Wait for dial tone
Wait delay 2 seconds
Pause delay 2 seconds
Call timeout 30 seconds
Answer on 1 ring
Autocallback disabled
DTE OPTIONS
Async data
DTE rate - 115200
8 bit, no parity
Async controlled dialer
AT command set enabled
DTR disconnects
DSR forced high
CTS forced high
DTE fallback disabled
Options retained at disconnect
Modem 3600
Advertisement
Table of Contents
