Black Box 3600 User Manual page 62

AT Commands
Digit / Word Selection V
The V command tells the modem which type of response message to
show on the monitor. Some software requires digit response messages
but words are easier to remember.
Command
V
V1
Response Displays Q
The Q command enables or disables response messages. The modem
still responds to commands when the response display is inhibited.
Command
Q
Q1
Q2
Negotiation Displays W
The W command enables or disables negotiation response messages.
These messages are verbose negotiation status displays to alert the user
to the link rate, protocol, and DTE rate.
Command
W
W1
W2
Protocol Result Codes \V
Enable or disable protocol result codes. Table 5-1 lists these codes.
Command
\V
\V1
5-6
Operation
Enables digit response messages
Enables word response messages
Operation
Response display on
Response display off
Response display on in originate mode only
Operation
Disables negotiation displays
Enables negotiation displays
Displays DCE link rate only
Operation
Disable protocol result codes
Enable protocol result codes
Modem 3600