Table of Contents
Advertisement
PIN
SETSCREW
DOWNROD
Figure 10
26. You have now completed the initial assembly of
your new ceiling fan. You can now proceed with
hanging and wiring your fan.
How to Hang
Your Ceiling Fan
WARNING
!
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 11). Do NOT hang this
fan on an 8' ceiling.
AT LEAST
7'
Figure 11
1. Securely attach the hanger bracket to the outlet box
using the two screws supplied with the outlet box
(Figure 12).
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support", and use screws supplied with
outlet box. Most outlet boxes commonly used for
support of light fixtures are not acceptable for fan
support and may need to be replaced. Consult a
qualified electrician if in doubt.
HANGER BALL
CEILING COVER
CEILING
FLOOR
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
Figure 12
2. Carefully lift the fan and seat the hanger
ball/downrod assembly on the hanger bracket that
was just attached to the outlet box (Figure 13). Be
sure the groove in the ball is lined up with tab on
the hanger bracket (Figure 12).
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
NOTE: CEILING COVER, SUPPL Y WIRES AND FAN WIRES
OMITTED FOR CLARITY.
Figure 13
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and the
hanger bracket.
7
WARNING
OUTLET
BOX
HANGER
BRACKET
TAB
WARNING
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
WARNING
U.L. Model No.: CF3100
Advertisement
Table of Contents
