Media Card Reader Board - HP 210 G1 Maintenance And Service Manual

Media card reader board

Description
Media card reader board (includes cable)
Before removing the media card reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service door (see
b. Display assembly (see
c. Bottom cover (see
Remove the media card reader board:
1. Release the ZIF connector (1) to which the media card reader board cable is attached, and then
disconnect the media card reader board cable from the system board.
2. Remove the Phillips PM2.0×4.5 screw (2) that secures the media card reader board to the
top cover.
3. Remove the media card reader board (3) and cable.
Reverse this procedure to install the media card reader board.
Battery on page 40), and then remove the following components:
Service door on page 41)
Display assembly on page
Bottom cover on page
53)
61)
Component replacement procedures
Spare part number
730897-001
67