Media Card Reader/Usb Connector Board - HP COMPAQ 6715S Maintenance And Service Manual

Remove the speakers (3).
3.
Reverse this procedure to install the speakers.

Media Card Reader/USB connector board

NOTE: This section applies only to HP Compaq 6715b computer models.
Description
Media Card Reader/USB connector board (includes Media Card Reader/USB connector board
cable)
Before removing the Media Card Reader/USB connector board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Memory/WLAN module compartment cover (see
b.
Optical drive (see
c.
Keyboard (see
d.
Switch cover (see
e.
78 Chapter 4 Removal and replacement procedures
Battery on page 41).
Hard drive on page 45)
Optical drive on page
Keyboard on page 56)
Switch cover on page
Expansion memory module on page
54)
62)
Spare part number
443883-001
49)