5.
Remove the bottom cover from the top cover.
Reverse this procedure to install the bottom cover.
Power button board
Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service door (see
b.
Display assembly (see
c.
Bottom cover (see
Remove the power button board:
1.
Remove the two Phillips PM2.0×2.75 screws (1) that secure the power button board to the
top cover.
2.
Detach the power button board cable (2) from the top cover. (The power button board cable is
attached to the top cover with double-sided tape.)
Battery on page
40), and then remove the following components:
Service door on page
41)
Display assembly on page
Bottom cover on page
53)
61)
Component replacement procedures
Spare part number
730899-001
63