Power Connector Cable - HP 210 G1 Maintenance And Service Manual

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service door (see
Remove the power connector cable:
1. Remove the two Phillips PM2.0×5.5 screws (1) and the Phillips PM2.5×10.5 screw (2) that
secure the display assembly right hinge to the computer.
2. Open the display assembly right hinge (3) as far as it will open.
3. Disconnect the power connector cable (4) from the system board.
4. Release the power connector cable from the retention clips (5) and routing channel built into the
bottom cover.
Battery on page 40).
Service door on page 41).
Component replacement procedures
Spare part number
730900-001
59