Westell Technologies Versalink 327W User Manual page 98

User Guide
WAN PORT
Status
VPI
VCI
Protocol
NOTE: The configuration
specified by your Service
Provider will determine which
Protocols are available to you.
Bridge Broadcast
Bridge Multicast
030-300408 Rev. B
Factory Default = DSLATM PORT
Possible Responses:
DSLATM PORT
ETHERNET PORT 1
Allows you to enable or disable your VC (Virtual Connection)
Displays the VPI (Virtual Path Indicator) value for a particular VC, which is
defined by your Service Provider.
Displays the VCI (Virtual Channel Indicator) value for a particular VC,
which is defined by your Service Provider.
Displays the Protocol for each VC, which is specified by your Service
Provider.
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer
Mode). This is an ATM encapsulation of the IP protocol.
Factory Default = CHECKED
When this setting is CHECKED, VersaLink will allow Broadcast IP packets
to/from the WAN.
When this setting is NOT CHECKED, VersaLink will block Broadcast IP
packets to/from the WAN.
This setting is only valid if one of the Virtual Channels is configured for
Bridge mode.
Factory Default = CHECKED
When this setting is CHECKED, VersaLink will allow Multicast IP packets
to/from the WAN.
When this setting is NOT CHECKED, VersaLink will block Multicast IP
98
VersaLink™ Gateway (Model 327W)
August 2005