Westell Technologies Versalink 327W User Manual page 94

User Guide
NOTE: Whenever the PPP Status displays DOWN, you do not have a PPP session established. If your Gateway's
connection setting is set to "Always On," after a brief delay the PPP session will be established automatically and
the PPP Status will display UP. If the connection setting is set to "Manual," you must click on the Connect button
to establish a PPP session. Once the PPP session has been established (PPP Status displays UP), you may proceed
with your Gateway's configuration.
13.5.7 VLAN
The following settings will be displayed if you select VLAN from the Advanced LAN menu.
VLAN Enable
LAN Port
VLAN ID
VLAN Priority
Outgoing VLAN Tag
030-300408 Rev. B
Factory Default = DISABLED
If this box is check, VLAN will be Enabled. This will allow VLAN
tagging to occur according to the data port's configuration.
This allows you to select the LAN port that you wish to configure.
Possible responses are:
Ethernet Port 1
Ethernet Port 2
Ethernet Port 3
Ethernet Port 4
WLAN Port
This allows you to assign a VLAN ID to the port.
Possible responses are:
1 through 8
This allows you to set the VLAN priority for the port.
Possible responses are:
0 through 7
This allows you to keep or remove the VLAN tag on the port when
data is outgoing.
94
VersaLink™ Gateway (Model 327W)
August 2005