Westell Technologies Versalink 327W User Manual page 93

User Guide
If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warnings
messages may be displayed via pop-up screens. If this occurs, check settings in the Public LAN Configuration
screen.
Warning Message
Start Address is not part of the Subnet
End Address is not part of the Subnet
End Address is below the Start Address
Lease time must be greater than 10 seconds
Seconds must be between 0 and 59
Minutes must be between 0 and 59
Hours must be between 0 and 23
If you clicked on OK in the Load new Public LAN configuration? screen, the following pop-up screen will be
displayed. This will allow the modem to be reset and the new configuration will take effect. Click on OK.
If you clicked on OK in the preceding screen, the following screen will be displayed. VersaLink will be reset and
the new configuration will take effect.
After a brief delay, the home page will be displayed. Confirm that you have a DSL sync and that your PPP session
displays UP. (Click on the connect button to establish a PPP session).
030-300408 Rev. B
VersaLink™ Gateway (Model 327W)
Check Public LAN DHCP Settings
Check the value in the DHCP Start Address field
Check the value in the DHCP End Address field
Check the value in the DHCP End Address field
Check the values in the DHCP Lease Time fields
Check the Seconds field at DHCP Lease Time
Check the Minutes field at DHCP Lease Time
Check the Hours field at DHCP Lease Time
93 August 2005