Westell Technologies Versalink 327W User Manual page 43

User Guide VersaLink™ Gateway (Model 327W)
Select the Ethernet Configuration
After clicking on OK in the preceding screen, the Network screen will be displayed. The Network screen shows the
settings for the newly created location. From the Configure field in the Network screen, select Built-in Ethernet.
Click on Save.
NOTE: Default settings for the Built-in Ethernet configuration are sufficient to operate VersaLink.
Check the IP Connection
To verify that the computer is communicating with VersaLink, follow the instructions below.
1. Go to the "Apple" icon in the upper-right corner of the screen and select System Preferences.
2. From the System Preferences screen, click on the Network icon. The Network screen will be displayed.
3. From the Configure field in the Network screen, select Built-in Ethernet.
4. View the IP address field. An IP address that begins with 192.168.1 should be displayed.
NOTE: The DHCP server provides this IP address. If this IP address is not displayed, check VersaLink's wiring
connection to the PC. If necessary, refer to section 5 for hardware installation instructions.
030-300408 Rev. B 43 August 2005